MC PCIe-DIO24 Uživatelská příručka stáhnout pdf (Strana 28)

The Trigger Out port is optionally used to synchronize external

equipment with I

C Bus events or data match pattern. This port is

located on the front of the pod, and uses a BNC type connector.

Output lines are provided for signal and ground.

When Trigger Out is enabled and configured with the software

Trigger Out dialog, a high to low transition on the signal line occurs

on:

a. I

C Bus Start events.

b. I

C Bus Stop events.

c. I

C Bus Acknowledge event.

d. I

C Bus Negative Acknowledge event.

e. Bit Pattern Match.

Connect the pod to external equipment using a BNC to external

equipment cable (not provided).

2. Auxiliary Port (optional)

The Auxiliary port is used to connect the I

C Bus Monitor pod to

external equipment. This port is located on the rear of the pod, and

uses a DB-9M type connector. Auxiliary lines include:

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Žádné komentáře

MC PCIe-DIO24 Uživatelská příručka Strana 28